Troubleshooting - Procedures - Sundance Spas Altmar Owner's Manual

16.0

Troubleshooting - Procedures

In the unlikely event your hot tub is not working the way you believe it
should, please first review all the installation and operating instructions in
this manual and check the message on the panel display; second, if you
are still not satisfied it is working properly, please follow the appropriate
troubleshooting instructions.
PROBLEM
None of the
components
operate ( i.e.
pump, blower,
light)
Pump does not
operate and icon
does
Pump Priming Instructions:
This method must be used for the jets pumps because these pumps
are not connected to the main filter system in any way.
1. Turn off the power to the spa.
2. Remove the handle from the massage selector supplied by the pump
you are priming.
3. Loosen the massage selector's cap slightly (counterclockwise),
listening for the air to seep out.
4. Tighten the cap finger tight, replace the handle, and turn the spa's
power back on.
CAUTION: If freezing conditions exist and pump is not operational,
take measures to protect the system from freeze damage. See Section
titled "Winterizing", page 67.
PROCEdURE
Check the control panel lights.
1. If there are letters or symbols displayed on
the screen, refer to the previous section to
determine meaning and action required.
2. If nothing appears on the screen:
A. Check the household circuit breaker.
B. Contact you Sundance Spas dealer or
qualified service technician.
Depress JETS Button.
1. If no sound is detected or if a buzzing sound
is detected, turn off power to the spa and
contact your authorized dealer or qualified
service technician.
2. If motor operates, but now water flows to
jets:
A. Pump may not be properly primed. See
instructions below.
B. Contact your Sundance Spas dealer or
qualified service technician.
880 SERIES
Page 77