Quick Release Door (Except Maxxus And Aspen Models) - Sundance Spas Altmar Owner's Manual

2. Rinse debris from all outer filter
(1) pleats using a garden hose
and high-pressure nozzle. Repeat
process until all filter pleats are
clean. Then rinse debris from
inside of filter (1). If chemical
cleaners are used, follow
manufacturers instructions.
Lightly rise filter insert (2) and
place in clean location. *DO NOT
use chemical cleaners or high-pressure nozzle on insert (2) or it
may be damaged, come apart or allow impurities to re-enter the
water, increasing the risk of contracting a waterborne illness (e.g. an
infection bacteria or virus) and/or respiratory ailments.
3. Install filter insert (2) into outer pleated filter (1) by gently sliding inward
until a slight resistance is felt approximately 1/4" from bottom. Lightly
tap insert end with palm of hand to "snap" in place. Insert is properly
installed when end cap rests "flush" against outer filter end cap.
4. Install Filter assembly back into spa by performing step 2 in reverse
order. Tighten filter nut so it just touches the filter face. DO NOT
OVERTIGHTEN!
5. Turn power to spa back on.
Replacement filter cartridges may be purchased from your Sundance
Spas dealer.
13.2 Quick Release door (Except Maxxus
and Aspen Models)
The Quick Release Door provides easy access
to the equipment bay and components without
having to unscrew the panel. To remove the
Quick Release Door follow the steps below:
1. Locate the two Quick Release Door buttons on
the top corners of the center panel, Figure A.
2. Press the buttons to release the panel from the
spa frame, Figure B.
3. Slowly and gently tilt the panel forward to remove.
This will expose the equipment bay for easy
access to components like the CLEARRAY
System and the Quick Drain Valve, Figure
C. Place the panel in a safe location to
prevent from damaging it.
4. To reinstall the panel just follow the steps
above in reverse order.
1
1
Top
880 SERIES
2
2*
SENTRY
Figure A
Figure B
Figure C
Page 63