Sundance Spas Altmar Owner's Manual page 82

880 SERIES
Page 76
Power failure. Power fluctuation in the secondary
power line is causing the DC voltage to be low. Try to
reset power to spa. Should the power level return to
normal, the PF error will reset itself. If the error returns,
contact your Sundance Spas dealer or qualified service
technician.
Power failure. Power fluctuation in the secondary
power line is causing the DC voltage to be low. Try
to reset power to spa. Should the power level return
to normal, the PF error would reset. If the error
returns, contact your Sundance Spas dealer or
qualified service technician.
WARNING: RISk OF HYPERTHERMIA
!
(OVER-HEATING) CAUSING SEVERE
INjURY, BURNS, OR WELTS.
"WATCHDOG" (hot tub is deactivated). Water
temperature is above acceptable limits. dO NOT
ENTER THE WATER! Remove hot tub cover to
speed cooling. A problem has been detected which
could cause damage to the hot tub or its
components. Contact your Sundance Spas dealer
or qualified service technician.
OPEN SENSOR (heater disabled) or SHORTED
SENSOR (hot tub is deactivated)
The high-limit temperature sensor is non-functional.
This must be repaired only by an Sundance Spas
dealer or qualified service technician.
OPEN or SHORTED SENSOR (heater disabled)
The main temperature sensor is non-functional. This
must be repaired only by an Sundance Spas dealer
or qualified service technician.
CLOSED or SHORTED FLOW SWITCH ON
SYSTEM STARTUP (system disabled) Flow switch
is non-functional. This must be repaired only by an
Sundance Spas dealer or qualified service
technician.
UV lamp needs to be replaced. The message will
flash between "blb" and the water temperature. The
countdown timer for the UV lamp needs to be reset
(Section 12.8, page 59). A new UV lamp can be
purchased from a local Sundance Spas dealer.