Hot Tub Fill Up Procedure - Sundance Spas Altmar Owner's Manual

Voltage
Frequency
Max. Current Draw
Wattage
Number of Wires
Standard 12,1 Amp (2,8 kW) configuration. The heater will not operate
*
while the jets pump is running.
Alternate 23,6 Amp (5,4 kW) configuration. The heater will operate
**
while the jets pump is running.
8.0

Hot Tub Fill Up Procedure

For best results, read each step in its entirety before proceeding with that
step.
1. Prepare The Hot Tub For Filling
• Clear all debris from the hot tub. (Although the hot tub shell has
been polished at the factory, you may want to treat it with a specially
formulated hot tub cleaner.) Consult your dealer for additional
information prior to filling hot tub.
• Remove filter lid (Sections 9.4-9.25, pages
cartridge from filter bucket as illustrated in Section 13.1.
2. Fill Hot Tub
• Place the end of your garden hose into the empty filter bucket.
CAUTION: TO dECREASE BUILd UP ON COMPONENTS ANd
MINIMIZE ACRYLIC dAMAGE.
Never fill with water from a water softener. If your water is extremely
"hard", it is preferable to fill half-way with hard water and the rest of
the way with softened water. Water that is too soft can be corrosive
to metal components.
!
WARNING:
•
dISEASE.
Fill hot tub with clean tap water from garden hose, to reduce risk of
contracting a waterborne illness (e.g. an infection, bacteria or virus)
and/or respiratory ailments. Fill until water covers all jets but does not
touch the bottom of the lowest headrest. (DO NOT OVERFILL!)
Export 50 Hz Capri
230V/12,1A
230 VAC
50 Hz
12,1 Amps*
2,8 kW
3
TO dECREASE RISk OF INFECTION OR
880 SERIES
230V/23,6A
230 VAC
50 Hz
23,6 Amps**
5,4 kW
3
25-46), then remove filter
Page 17