Important Hot Tub Owner Information; Fcc Notice - Sundance Spas Altmar Owner's Manual

880 series
Table of Contents

Advertisement

1.0

Important Hot Tub Owner Information

Your Sundance
is capable of providing many years of trouble-free use. However,
because heat retentive materials are utilized to insulate the hot tub for
efficient operation, an uncovered hot tub surface and wall fittings directly
exposed to sunlight and high temperatures for an extended period are
subject to permanent damage or discoloration. Damage caused by
exposing the hot tub to this abuse is not covered under warranty. We
recommend that you always keep the hot tub full of water when it is
exposed to direct sunlight and that you keep the Sundance insulating
cover in place at all times when the hot tub is not in use. Read and
carefully follow the requirements for your hot tub's support base found in
the Section 4.0 titled, "Locating Your Sundance Hot Tub" (page 9) or as
prescribed by your authorized Sundance Spas dealer.
Sundance hot tubs constantly strives to offer the finest hot tubs
available, therefore, modifications and enhancements may be made
which affect the specifications, illustrations and/or instructions contained
herein.
2.0

FCC Notice

This equipment has been tested and found to comply with the limits for
a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following
measures:
1. Rearrange or relocate the receiving antenna;
2. Increase the separation between the equipment and receiver;
3. Connect the equipment into an outlet on a circuit different from the
circuit connected;
4. Consult the dealer or an experienced radio/TV technician for help.
(Changes or modifications not expressly approved by the party
responsible for FCC compliance could void the user's authority to
operate this equipment).
®
hot tub is constructed to the highest standards and
880 SERIES
Page 1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents