Sundance Spas Altmar Owner's Manual page 25

temperature increases or decreases by one degree each time either
button is pressed.
• The heater will turn off when the temperature corresponding to the
thermostat setting is achieved.
Important Heater details:
• The maximum temperature for which the hot tub can be set is
104°F (40°C) and the minimum is 80°F (27°C).
• For Cameo and Optima hot tubs powered with a 40 amp service,
turn off jets pump #1 and jets pump #2 to operate heater.
• Setting the thermostat at maximum will not accelerate the heating
process. This will only result in a higher ultimate temperature.
• The heater operates until the water reaches the programmed "set
temperature", then turns off. The heater will reactivate after the
water cools to approximately 1° below the "set temperature."
8. Place Cover On Hot Tub
• Keeping the insulating cover in place anytime the hot tub is not in
use will reduce the time required for heating, thereby minimizing
operating costs.
• The time required for initial heat-up will vary depending on the
starting water temperature.
dANGER:
!
Check water temperature carefully before entering hot
tub! Excessive water temperature can cause burns,
welts and body temperature to rise, hyperthermia (over-
heating).
decontamination Procedure (Steps 9-15)
Steps 9-15 below are only required when sanitizer levels are unstable
after performing steps 1-6 above. Disregard steps 9-15 below if sanitizer
levels remain stable after performing steps 1-6 above (refer to the inside
cover of the manual).
9. Add 2.5 ounces of sodium dichlor for every 100 gallons of water. Refer
to the table (below) for approximate water fill capacity by model.
CAUTION: RISk OF PERSONAL INjURY OR SPA dAMAGE!
!
Never add chlorine tablets (trichlor) or acid to your hot tub
for any reason! These chemicals may damage components
within your hot tub, burn or irritate your skin, create a rash,
and void the manufacturer warranty for your spa.
RISk OF PERSONAL INjURY.
880 SERIES
Page 19