Sundance Spas Altmar Owner's Manual page 2

880 series
Table of Contents

Advertisement

Attention New Hot Tub Owner!
Congratulations on the purchase of your new Sundance
a list of automated functions performed by your hot tub. These functions are listed
below in an attempt to suppress any operational concerns you may have during
the first 24-hours of ownership! Also listed below are important maintenance
recommendations you should observe on a regular basis to protect your new
investment.
Automated Spa Operations
Your new hot tub is equipped with an automated "blow-out" cycle that clears all
plumbing lines daily to promote maximum water sanitation. Each day at 12:00
PM (noon), pump 2, pump 3 (Maxxus™/Aspen™ Models) and the blower will
automatically turn on for a period of one minute, then go off. Then pump 1 will turn
on and run for one minute to complete the blow-out cycle. Be aware, the factory
programmed blow-out cycle cannot be canceled or altered!
Maintain Healthy Spa Water
Always maintain your hot tub's water chemistry within the following parameters:
pH
Free chlorine
Free Bromine
Total Alkalinity
Calcium Hardness
IMPORTANT: CLEARRAY™ Water Purification System is factory installed. If
the CLEARRAY™ system is altered or is not operating efficiently follow the
"without CLEARRAY™" water chemistry parameters. Such parameters are de-
fined by the Association of Pool and Spa Professionals. CLEARRAY™ requires
an annual lamp replacement to properly sanitize your water.
!
TO dECREASE RISk OF INFECTION OR dISEASE!
maintain your spa filter as outlined below to ensure healthy spa water. Refer to
pages 61-62 for additional information.
Required Filter Maintenance
Your new hot tub is equipped with an advanced MICROCLEAN® Ultra water
filtration system that provides unsurpassed water quality! To ensure maximum
water quality at all times, you should replace the filter cartridge every six months,
or earlier as necessary. The filter cartridge is designed to be thrown away!
Attempts to reuse the filter cartridge may result in the re-release of unwanted
particles back into the hot tub. See pages 61-62 for detailed filter cartridge
replacement instructions.
Required Water Replacement
!
TO dECREASE RISk OF INFECTION OR dISEASE!
replace the hot tub's water every 3 to 6 months. The frequency depends on a
number of variables including frequency of use, number of users, and attention
paid to water quality maintenance. You will know it is time for a change when you
cannot control sudsing and/or you can no longer get the normal feel or sparkle to
the water, even though the key water balance measurements are all within the
proper parameters. See pages 69-70 for additional information.
With CLEARRAY™
7.4-7.6
no less than 1.0 ppm
no less than 2.0 ppm
100-120 ppm
150-250 ppm
®
hot tub! The following is
Without CLEARRAY™
7.4-7.6
3.0-4.0 ppm
2.0-4.0 ppm
100-120 ppm
150-250 ppm
Always
You should

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents