Activate Jets Pumps - Sundance Spas Altmar Owner's Manual

880 series
Table of Contents

Advertisement

880 SERIES
IMPORTANT: Always fill your hot tub through the filter bucket after
draining. Failure to do so may cause air to be trapped in either
pump, preventing the pump from circulating water. Remove the
hose and replace the filter cartridge as illustrated in Section 13.1.
3. Turn On Power
Turn on power to hot tub at the home's circuit breaker to start boot
up sequence. The heater and filter/circulation pump will automatically
activate. If the control panel LCD flashes water temperature and
"COOL" or "ICE", this is normal.

4. Activate jets Pumps

Turn on all jet(s) pumps and blower to ensure proper
mixing when adding start up chemical in step 5.
5. Add Start-Up Chemicals
Add the hot tub water chemicals as recommended by your Sundance
Spas dealer. See Section titled "Water Quality Maintenance" (page
69) for general guidance.
WARNING:
!
Never leave chemicals opened and accessible to anyone.
Use chemicals according to the vendors instructions. Always
store chemicals in a safe and/or locked location. Keep away
from and out of reach of children.
6. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading no less than 1.0 ppm free chlorine
or 2.0 ppm bromine. To ensure healthy water conditions, always
maintain a constant sanitizer reading within the levels recommended
on the inside cover of this manual. If sanitizer levels cannot be
stabilized, perform the decontamination procedure steps 9-15 on the
following page.
Note: The "decontamination procedure" steps 9-15 should also be used
after the hot tub has been "Winterized" (Section 13.9) or has been sitting
without power for an extended period.
7. Set Hot Tub To Heat
To warm hot tub water to a comfortable temperature, follow
these steps:
The LCD display on
temperature of the hot tub water. Press either the COOLER (Down)
or WARMER (Up) button once to display the "set" temperature for
5 seconds. If you want the water to heat to a different temperature,
simply press COOLER or WARMER within 5 seconds. The set
Page 18
RISk OF POISONING OR dEATH.
the control panel displays the actual

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents