Programmable Filter/Heating Cycles (Economy Mode Only) - Sundance Spas Altmar Owner's Manual

880 SERIES
5. Press the (dISPLAY)
main water temperature display.
Note: If no button is pressed within 30 seconds, all changes are
recorded and the screen automatically returns to the standard water
temperature display. When the standard mode is selected (Section 11.3),
the filter/circulation pump automatically turns on for a heat call regardless
of the pump's programmed start time and duration.
12.2

Programmable Filter/Heating Cycles (Economy Mode Only)

Your hot tub comes with four 30-minute filter cycles which activate the
filter/circulation pump while in economy mode. These cycles are factory
programmed to start at 6:00 AM, 12:00 (noon), 6:00 PM, and 12:00
(midnight). The control system allows you to easily adjust two separate
aspects of each cycle:
• The time of day at which it begins;
• The duration of the cycle.
Note: When "Economy" mode is selected (Section 11.3), the heater
activates only during a programmed filter cycle period. When a Summer
Logic condition is active (page 56), the filter/circulation pump will turn on
for all programmed filter cycles.
Summer Logic: In warm weather, the water temperature in the
hot tub may exceed the set temperature. This condition may occur
due to heat transference from the filter/circulation pump and jets
pumps. If the water temperature is higher than 95°F (35°C) and
rises two degrees above the set temperature, a "Summer Logic"
condition occurs that deactivates the filter/circulation pump and
CLEARRAY™. This safety feature cannot be altered! The filter/
circulation pump and CLEARRAY™ will remain off until the water
temperature cools to the set temperature (except between 9am-
11am when the filter/circulation pump runs for it's mandatory 2
hour cycle.)
Note: Pressing the select button at this time will reactivate the
circulation pump and waterfall feature for 1 hour. To help prevent
a "Summer Logic" condition, it may be necessary to reduce filter/
circulation pump cycle run times in warm weather.
Press the (MOdE)
adjustments, first press the (CYCLE)
programming mode. The LCD screen will display the following in the
upper right corner:
Page 56
button to save changes and recall the
button to select "Economy" mode. To make
*
button to enter the filter cycle
*Note: Number will vary
according to which filter
cycle is being programmed.