Panel Displays Oh; Panel Displays; Panel Displays Blb; 14.0 Troubleshooting Procedures - Sundance Spas Edison Owner's Manual

13.6

Panel Displays OH

WARNING: RISK OF HYPERTHERMIA (OVER-HEATING)
!
CAUSING SEVERE INJURY, BURNS, OR WELTS.
Water temperature is above acceptable limits. DO NOT
ENTER SPA! Water temperature has reached 112°F (44°C) and the low
speed pump has activated to circulate water through heater.
13.7

Panel Displays - - -

WARNING: RISK OF HYPERTHERMIA (OVER-HEATING)
!
CAUSING SEVERE INJURY, BURNS, OR WELTS.
Water temperature is above acceptable limits. DO NOT ENTER SPA!
The safety "Watchdog" software has been triggered and the spa is
deactivated. A problem has been detected which could cause damage to
the spa or its components. Contact your authorized Sundance dealer.
13.8

Panel Displays BLB

UV bulb needs to be replaced. The message will flash
between "blb" and the water temperature. The timer for the UV bulb
must also be reset, refer to Section 10.6, page 32. A new UV bulb can
be purchased from a local Sundance Spas dealer.

14.0 Troubleshooting Procedures

In the event your spa is not working the way it should, please first review
all the installation and operating instructions in this manual and check the
message on the panel display. If you are still not satisfied it is working
properly, please follow the appropriate troubleshooting instructions below.
Note: If any of the supply cords to the accessories are damaged, they
must be replaced by authorized service personnel.
14.1

None of the Components Operate (e.g. Pump, Light)

Check the following when none of the spa components operate
(e.g. jets pumps or light):
1. Is there power to the spa?
2. Is the household circuit breaker tripped?
3. Call your authorized dealer.
680 SERIES
Page 45