Ebm Installation - Avaya S9RM Installation And Operator's Manual

EBM Installation

A small amount of arcing may occur when connecting an EBM to the UPS. This is
normal and will not harm personnel. Insert the EBM cable into the UPS battery
connector quickly and firmly.
If you are installing the optional EBM(s), use the following steps:
1. The EBM cable has a cover that must be removed before
NOTE Keep the EBM cable cover for future use. If the EBM is stored or removed from
the UPS, the EBM cable cover must be installed as a safety precaution.
2. Plug the EBM cable into the UPS battery connector (see
3. If additional EBMs are to be installed, remove the EBM battery
4. Continue to the following section, "Power Connections."
Avaya S9RM 3000 VA, 120V UPS Site Preparation, Installation and Operator's Manual
C A U T I O N
installing the EBM(s). Remove the cover from the EBM cable as
shown in Figure 11.
Battery Connector Cover Screws
Figure 11. EBM Cable Cover
Figure 12).
connector cover (see Figure 11).
Plug the EBM cable of the second cabinet into the battery
connector on the first EBM. Repeat for each additional EBM.
Up to four EBMs may be connected to the UPS.
EBM Cable with Cover
:
700285596 Issue 1
Installation
23