Power Connections - Avaya S9RM Installation And Operator's Manual

Power Connections

NOTE Do not make unauthorized changes to the UPS; otherwise, damage may occur
to your equipment and void your warranty.
Use the following steps to install the UPS and PDM power connections:
1. Verify that the Bypass switch on the PDM is in the NORMAL
2. Plug the UPS power cord into the UPS-input connector on the
3. Plug the UPS L5-30 output receptacle (attached cord) into the
UPS-Input Connector
UPS-Output Connector
Bypass Switch
PDM
UPS
4. Plug the equipment to be protected into the PDM output
5. If an emergency power-off (disconnect) switch is required by
Avaya S9RM 3000 VA, 120V UPS Site Preparation, Installation and Operator's Manual
position (see Figure 13).
PDM rear panel.
UPS-output connector on the PDM rear panel.
Output Receptacle (L5-30R)
UPS Power Cord UPS Battery Connector
Figure 13. UPS with PDM Power Connections
receptacles. Distribute the load evenly between the rows of
receptacles.
DO NOT protect laser printers with the UPS because of the
exceptionally high power requirements of the heating elements.
local codes, see "Remote Emergency Power-Off" on page 27 to
install the REPO switch before powering on the UPS.
PDM Power Cord
Output Receptacles (Six 5-20R)
UPS Output Receptacle (L5-30)
:
700285596 Issue 1
Installation
25