Replacing Batteries; How To Replace Extended Battery Modules - Avaya S9RM Installation And Operator's Manual

3000 va, 120v uninterruptible power systems

Hide thumbs Also See for S9RM:

Table of Contents

UPS Maintenance

Replacing Batteries

NOTE DO NOT DISCONNECT the batteries while the UPS is in Battery mode.

With the hot-swappable battery feature, UPS batteries can be replaced

easily without turning the UPS off or disconnecting the load.

If you prefer to remove input power to change the battery, press and

hold the Off

remove utility power from the UPS.

Consider all warnings, cautions, and notes before replacing batteries.

Batteries can present a risk of electrical shock or burn from high short-circuit

current. The following precautions should be observed: 1) Remove watches, rings,

or other metal objects; 2) Use tools with insulated handles; 3) Do not lay tools or

metal parts on top of batteries.

ELECTRIC ENERGY HAZARD. Do not attempt to alter any battery wiring or

connectors. Attempting to alter wiring can cause injury.

Use the following procedure to replace EBMs:

1. Unplug the EBM cable from the UPS.

2. If the UPS is in a tower configuration, remove the EBM brackets

3. If the EBM has pedestals installed, remove the pedestals and

4. If the UPS is in a rack, install the mounting handles and

5. Replace the EBM. See "Recycling the Used Battery" on page 48

6. Reinstall the pedestals if removed in Step 3.

7. Reinstall the EBM brackets if removed in Step 2.

Avaya S9RM 3000 VA, 120V UPS Site Preparation, Installation and Operator's Manual

button for approximately three seconds, then unplug or

W A R N I N G

If additional EBMs are installed, unplug the EBM cable from the

battery connector on each EBM.

from the top.

retain.

brackets on the new EBM.

for proper disposal.

700285596 Issue 1

Table of Contents