Bypass Mode; Standby Mode; Sleep Mode - Avaya S9RM Installation And Operator's Manual

3000 va, 120v uninterruptible power systems

Hide thumbs Also See for S9RM:

Table of Contents

Bypass Mode

In the event of a UPS overload or internal failure, the UPS transfers your

equipment to utility power. Battery mode is not available; however, the

utility power continues to be passively filtered by the UPS. The

: The UPS has an overtemperature condition.

: The UPS has an overload condition of 101 to 150% for 30 seconds.

: The UPS detects a fault in the battery or UPS electronics.

When the UPS is turned off and remains plugged into a power outlet,

the UPS is in Standby mode. The

indicators are off, indicating that power is not available from the UPS

output receptacles. The battery recharges when necessary.

If the UPS is on battery for approximately five minutes and supporting a

small electrical load ( ˆ 10%), the UPS shuts down the load. This feature

conserves battery power. To enable this feature, contact your service

representative.

Avaya S9RM 3000 VA, 120V UPS Site Preparation, Installation and Operator's Manual

indicator illuminates. The UPS switches to Bypass mode when:

indicator flashes and the bar graph

700285596 Issue 1

Operation

Table of Contents