Troubleshooting Guide - Kenmore 110.42822200 User Manual

TROUBLESHOOTING GUIDE
WON'T POWER UP. (Touch-pads
do not respond when pressed)
Check the line voltage and for blown fuses.
Check for voltage going to Central Control Unit (CCU) by listen
i n g f o r a c l i c k i n t h e C C U w h e n u n i t i s p l u g g e d i n . l f n o c l i c k
replace CCU.
Unplug the unit before continuing.
Check continuity of line cord and line filter.
Check harness connections to CCU.
Check touch-pad/LED assembly.
WON'T START CYCLE
1. Open and close the door. The door has to be opened between
consecutive wash cycles.
2. Check the door switch/lock unit using the diagnostics.
3. lf Door is Locked, Drain the Unit.
4. Check the wire harness connections.
5. Check the touch-pad/LED
assembly.
WON'T SHUT OFF
Check for a Fault/Error Code on the display.
Press PAUSE/CANCEL
button on the touch-pad twice.
Check the touch-pad/LED
assembly
Check that the Drain hose and Drain Pump Filter is clear of
foreign objects and not plugged.
Check Drain Pump.
Check the CCU.
CONTROL WON'T ACCEPT
S E L E C T I O N S
1. Press PAUSE/CANCEL button on the touch-pad twice.
2. Drain the unit, then check that the Drain hose and Drain Pump
Filter is clear of foreign objects.
3. Chect</ Replace Touch-pad/LED assembly.
4. Check harness connections.
5. Check the CCU.
1 . Verify the unit is level.
2. Verify Dispenser Drawer is not clogged with detergent.
3. Check water connections
to the unit and within the unit.
for plugged screen in water source.
Check Dispense molor.
Check harness connections.
Check CCU.
W O N ' T D I S P E N S E
Check installation.
Check inlet valves.
Check water connections to the unit and within the unit.
for plugged screen in water source.
Check Operating Pressure Switch.
Check the CCU.
Check under problem "WON'T DISPENSE'
1 .
z .
4 .
5 .
6 .
5 - 1 0