Touch Pad/Led Assembly; Modifiers; Wash/Rinse Temp; Auto Temp Control - Kenmore 110.42822200 User Manual

2. Select a Wash Cycle.
3. Select AUTO SOAK.
NOTE: For cycles with hot wash temperatures,
the soak temperature will be set to warm;
otherwise, the soak temperature will be the
same as the wash temperature.
4. Select and hold START (approximately 1
second). After soaking, the washer drains
and the wash cycle starts.
Without a Wash Cycle: Provides a soak time
with warm or cold water followed by drain.
1. Add detergent only to the Prewash compart-
ment of the Dispenser Drawer.
2. Select DRAIN/SPIN or RINSE/SPIN first.
then AUTO SOAK.
3. Choose the desired soak temperature.
4. Select and hold START (approximately 1
se c o n d) .
2n d R i n s e
A second rinse can be used to ensure the
removal of detergent or bleach residue from
garments. This option provides an additional
rinse with the same water temperature as the
first rinse.
Extended Spin
Use this option to add an additional spin to any
cycle to improve the "fluff" of your laundry, to
reduce drying time, and to save energy.
Modifiers
Preset cycle settings of Water Temperature,
Wash/Rinse, and Spin Speed can be changed.
You can change a modifier after starting a cycle
anytime before the selected modifier begins.
Touch Pad/LED Assembly
.
To change the water temperature, select the
WATER TEMP button untilthe desired
setting glows.
.
To change the spin speed, select the SPIN
SPEED button until the desired setting
glows.
.
To change the loudness of the End of Cycle
Signal, select E ND of C YCLE SI GNAL.
Wash/Rinse Temp
Select a water temperature based on the type
of load you are washing. Use the warmest
water safe for fabrics. Follow garment label
instructions.
Warm rinses leave the loads dryer than cold
rinses. Warm rinses increase wrinkling. In cold
climates, a warm rinse makes the load
more comfortable to handle. Cold rinses save
energy.
Auto Temp Control
ATC (Auto Temp Control) electronically senses
and maintains a uniform water temperature.
ATC regulates incoming hot and cold water. The
ATC is automatically turned ON when a cycle is
selected.
.
ATC ensures consistent cleaning.
.
ATC works for the wash temperature with
Extra HoVCold, HoVCold, WarmMarm,
Warm/Cold, and Cold/Cold settings.
.
The Cold rinse temperatures depend on the
cold water at the tap.
.
For the Tap Cold/Cold setting, both wash
and rinse temperatures
depend on the cold
water at the tap.
.
The Warm rinse setting regulates the water
temperature at approximately
104"F (40'C).
Touchpad/LED
Assembly
Ribbon Gable
Fig.2-10
The Touch Pad/LED Assembly, (Fig. 2-10), is a single assembly and is connected to the Central
Control Unit by a ribbon cable. This assembly contains all of the buttons, LEDs and ribbon cable
and printed circuit boards for the user to operate the washer. The interfaces the consumer inputs
to the Central Control Unit.
2 - 6