Error Codes - Kenmore 110.42822200 User Manual

ERROR CODES
No water detected entering machine or Pressure swilch trip not detected.
lf after 30 seconds the control does not detect water entering machine and then
valves will be turned off and the error code will be displayed.
O r
lf the control has turned the water valves on and after B minutes the f low meter has
detected 10.5 gallons of water passing through it, but has not detected the pressure
switch trip, the valves will be turned off and the error code willflash.
Press PAUSE/CANCEL twice to clear the display.
PotentialCauses
.
lf there is no water in the unit:
. Make sure that both valves at the water source(s) are lurned on allthe way.
. Check for plugged or kinked inlet hoses or plugged screens in the inlet valves
. Verify inlet valve operation
.
lf there is water in the unit:
. Verify Drain pump operation
. Pressure Switch Hose is in good condition and properly connecled to Tub and
Pressure switch
.
Verify there is not a siphon problem
.
Verify wire harness connections to; Inlet Valves, Pressure Switch, Drain Pump,
Flow Meter, and CentralControl
Unit (CCU)
.
Check all hoses for possible leaks
.
Verify pressure switch operation
.
Verify flow meter operation
.
Verify CCU operation
Long Drain
lf the drain time exceeds 8 minutes. the water valves are turned off and "F/02" is
f lashed.
Press PAUSE/CANCEL
twice to clear the display.
NOTE: After 4 minutes the "Sud" error will be displayed, then 4 minutes later
the FlO2 error code will be displayed.
PotentialCauses
. Check the drain hose and make sure it is not plugged or kinked
.
Check the electrical connections at the pump and make sure the pump is run-
n i n g .
.
Check the drain pump filter for foreign objects
.
lf the above does not correct the problem replace the pump
Water Temperature Sensor Error
lf during the water heating step in the wash cycle, the water temperature sensor
(NTC) value is out ol range, the "F/05" error code will be displayed.
PotentialCauses
.
Check the Water Temperature Sensor
.
Check connections to the Water Temperature Sensor