Electrical Requirements; Remove Transport System; Grounding Instructions; Installation Instructions (Washer) - Kenmore 110.42822200 User Manual

Electrical Requirements
)g
ELECTRICAL SHOCK HAZARD
Plug into a grounded 3 prong outlet.
Do not remove ground plug.
Do not use an adaoter.
Do not use an extension cord.
Failure to follow these instructions can
result in death or electrical shock.
a
a
A 12O-volt,
60-H2., AC-only, 15- or 2O-ampere,
f used electrical supply is required. Time-delay f use
or circuit breaker is recommended. lt is recom-
mended that a separate circuit serving only this
appliance be provided.
This washer is equipped with a power supply cord
having a 3 prong ground plug.
To minimize possible shock hazard, the cord must
be plugged into a mating, 3 prong, ground-type
outlet, grounded in accordance with local codes
and ordinances.
lf a mating outlet is not available,
it is the personal responsibility
and obligation of
the customer to have the properly grounded out-
let installed by a qualified electrician.
lf codes permit and a separate ground wrre is used,
it is recommended that a qualified electrician de-
termine that the ground path is adequate.
Do not ground to a gas pipe.
Check with a qualilied electrician if you are not
sure the washer is properly grounded.
Do not have a fuse in the neutral or oround circuit.
f . :l Frnq0 Sq"&rrr$lng pAlF
l S prong trftInotnp" typa trxt natrq@ctu
,3. Gn"trn*rp g*nrgr
4. fiil*er safig{r c*rs
GRO UND IN G I NSTRU CTI ON S
For a grounded, cord-connected washer:
This washer must be grounded. In the event of a
malfunction or breakdown, grounding will reduce
the risk of electrical shock by providing a path of
least resistance for electric current. This washer
is equipped with a cord having an equipment-
grounding conductor and a grounding plug. The
plug must be plugged into an appropriate outlet
that is properly installed and grounded in accor-
dance with all local codes and ordinances.
WARNING: lmproper conneclion of the equip-
ment-grounding conductor can result in a risk of
electric shock. Check with a qualified electrician
or serviceman if you are in doubt as to whether
the appliance is properly grounded.
Do not modify the plug provided with the appli-
ance -
if it will not fit the outlet, have a proper outlet in-
stalled by a qualified electrician.
For a permanently connected washer:
This washer must be connected to a grounded
metal, permanenl wiring system, or an equipment
grounding conductor must be run with the circuit
conductors and connected to the equipment-
grounding lerminalor lead on the appliance.
INSTALLATION
INSTRUCTIONS
Remove Transport System
IMPORTANT: Position the washer so that the rear
of the unit is within approximately 3 feet (90 cm)
of the final location.
Excessive Weight Hazard
Use two or more people to move and in-
stall washer.
Failure to do so can result in back or other
injury.
1 - 3