Diagnostic Test; Starting The Test Mode; Test Program Control During Execution; Overview Test Program - Kenmore 110.42822200 User Manual

DIAGNOSTIC TEST
The control must be in the OFF state before pressing the touch-pad sequence to start the test.
Starting the test mode
Close the door.
Select the DRAIN/SPIN cycle.
Select NO SPIN by pressing the SPIN SELECT button five (5) times.
Push Prewash Option button four (4)times within five (5) seconds. C:00 will show in the display.
lf the Starting procedure fails, push PAUSE/CANCEL button. Then repeat the starting sequence.
Test Program Control during Execution
To advance to the next step of the test procedure, push Prewash Option button two (2) times.
Overview Test Program
C : 00
Door is Locked
Door Lock System
C : 0 1 Filling by cold water inlet valve
Flowmeter, Cold water inlet valve
C : O 2
Distribution system is set to Prewash position
Dispenser motor,
Dispenser contact
C : 0 3 Fill by hot water inlet valve
Hot water inlet valve
C : 0 4
Drum rotates clockwise at wash speed Motor. CIM control
C : 0 5
Heater is switched ON.
Drum rotates clockwise with wash speed.
lf there is not enough water in the tub, the
water inlet valve will be switched ON to fill-in
the minimum water quantity.
Heater. NTC
C : 0 6
Drain Pump is ON Drain Pump
C : 0 7 Drum rotates counterclockwise
from 35 to 90 rpm
within 15 seconds
Motor, CIM control
C : 0 8
Drum rotates counterclockwise
with max. speed
Drum speed > 1 100 rpm
Motor. CIM control
5 - 8