Removing The Main Control Box And Pressure Switch; Removing The Drive Motor; Removing The Pump Assembly - Kenmore 110.42822200 User Manual

REMOVING THE
MAIN CONTROL BOX
AND PRESSURE SWITCH
The main control box is a single assembly and
does not contain any serviceable parts. lt can be
removed by lifting the top plastic tabs securing it
to the back cabinet frame and sliding it towards
the front of the washer. (Fig. 3-19)
Tabs
ro remove,n"
p,".L11.1,1,'n.n,
rirst remove the
wiring harness retainer from the side of the cabi-
net. (Fig. 3-20)
rhendisconnectr^:t;,::rt^arnessconnecrors
and the pressure hose and turn the pressure
switch counterclockwise to release it from the
cabinet. (Fig. 3-21)
Pressure Switch
REMOVING THE DRIVE MOTOR
The drive motor can be removed once the back
panel has been removed.
Twelve scr ew s secur e t he back panel to the
washer. Remove the 12 screws and remove the
back panel. Remove the Drive Belt.
Disconnect the wiring harness connectors and
ground wires from the drive motor terminals. Push
the wiring harness tie from the motor mounting
bracket.
Remove the mounting bolt securing the motor to
the tub. (Fig.3-22)
Fig.3-22
REMOVING THE PUMP ASSEMBLY
The pump assembly can be accessed once the
toe panel has been removed.
To clean out the large item filter, turn the large
knob counterclockwise
and pull it out. (Fig. 3-23)
Fig.3-23
Fig.3-21
3 - 6