Removing The Heating Element And Temperature Sensor; Removing The Tub And Drum Assembly - Kenmore 110.42822200 User Manual

REMOVING THE HEATING ELEMENT
AND TEMPERATURE
SENSOR
Disconnect the wiring harness connectors from
the heating element terminals and loosen but do
n o t re m o ve t h e 1 0 - mil l ime te r n u t b e twe e n th e
heating element terminals. (Fig. 3-29)Then slide
the heating element from the tub. Slide the tem-
perature sensor from the heating element bracket.
Temperature
Sensor
l O m m N u t
R E M O V I N G T H E T U B
AND DRUM ASSEMBLY
There are three concrete weights attached to the
tub assembly. All three must be removed for safe
removal of the tub assembly.
Access to the weight on the top front of the tub
requires removing the six screws securing the
top front frame member from the washer and re-
moving the frame member. (Fig. 3-30A)
Fig.3-304
Access to the weight on the top back of the tub
requires removing the two screws securing the
top frame member to the washer and removing
the frame member. (Fig. 3-308)
Top
Frame
(Back)
secured to the tub by three 13-
(Fig. 3-31)Remove the three
weight from the tub.
Bolts
Bolts
Fig.3-31
nuts from the tub for safekeep-
Each weight is
millimeter bolts.
bolts and lift the
Remove the flat
ing. (Fig. 3-32)
Top Frame (Front)
Fig.3-32
Fig.3-308
3 - 8