Accessing Components In The Console; Required Tools; Removing The Washer Top; Removing The Console From The Cabinet - Kenmore 110.42822200 User Manual

Required Tools
Th e S o ur ce 1 1 0
s ize s , T o rx T-1 5 ,
h am me r.
COMPONENT ACCESS
Front Loading Washer requires the use of Metric Socket Wrenches of various
T-20 and T-25 Drivers, a Crescent Wrench, a flat bladed screwdriver and a
ACCESSING COMPONENTS IN THE CONSOLE
Components accessible in the Console include the Console Cover and the Touch Pad/LED Assembly.
Access to these components requires that the top of the washer be removed.
Removing the Washer Top
Three screws secure the washer top at the back
of the washer. Remove the three screws and lift
the top from the washer. (Fig. 3-4)
'I f''l
lN, *:irKKrkl:'ffiff
:;,,.*;* 'f,.$
Fig.3-4
Removing the Console from the Cabinet
Disconnect the Touch Pad/LED Assembly ribbon
connector from the left side of the Central Con-
trol Unit (Fig.3-5) and release it from the wiring
harness brackets on the right side of the washer
to p .
Ribbon
Gonnector
Re m ove t he det ergent dispenser dr awer by
pressing down on the release tab at the back of
the drawer (Fig.3-6) and pulling it completely out
of the washer.
Gonsole
Release Tab
Fig.3-O
Once the drawer is removed, remove the screw
in the recessed hole next to the drawer opening.
Release the tab securing the right side of the con-
sole to the washer and remove the console. Be
sure the ribbon cable clears the cabinet frame.
Removing the Touch Pad/LED Assembly from
the Console
The Touch Pad/LED Assembly is a single unit and
contains the Push Buttons, LEDs, cable, etc. Re-
place the entire assembly if any components are
defective.
Touch Pad/
Gonsole Gover
F i g . 3 - 7
Drawer
Release Tab
Screws
Fig.3-5
3 - 2