Removing The Shock Absorbers; Accessing The Motor Control Unit - Kenmore 110.42822200 User Manual

To remove the pump assembly, begin by opening
the door covering the wiring harness connector
and disconnect the wiring harness from the pump
motor terminals. Remove the screw securing the
pump assembly to the washer frame. (Fig. 3-24)
Once the pump is removed the drain hose and
tube outlet hose can be removed.
A C C E S S I N G T H E
MOTOR CONTROL UNIT
Access to the Motor Control Unit may require
removing the left front shock absorber.
Using a flat bladed screwdriver, lift up on the
plastic tab under the front right corner of the
motor controller box. (Fig. 3-26 - INSET)
Fig.3-24
REMOVING THE SHOCK ABSORBERS
The tub is held in position by four shock absorb-
ers, two in front (Fig. 3-25)and two at the back.
Each shock absorber can be disconnected from
the tub by turning the top of the shock mount
counter clockwise. 90". The shock can be re-
moved from the washer by turning the bottom
shock mount counterclockwise. 90'.
Fig.3-25
Fig.3-26
Slide the box forward to
release the two tabs at
the back of the box from
the bottom panel of the
washer. (Fig.3-27)
Fig.3-27
Open the door on the control box to access to
the test points of the Motor Control Unit. (Fig. 3-
28)
3 - 7
Fig.3-28