Pressure Switch; Customer Interface And Cycle Selection - Kenmore 110.42822200 User Manual

Pressure Switch
The pressure switch is located in the top right rear corner of
the washer (Fig 2-7) This switch senses water level in the
wash tub. The control signal from the pressure switch is
sent to the Central Control Unit and is used to determine the
amount of water introduced into the wash tub durino the wash
c y c l e .
The pressure switch also senses the suds level in the wash
tub. lf excessive sudsing occurs, the washer starts an auto-
matic suds routine. The display will show the word SUDS. The
automatic suds routine adds additional rinse and drain opera-
tions untilthe suds level is reduced.
Customer Interface and Cycle Selection
Status Indicators
Fig.2-B
Pressure
Switch
Display
Delay
Start
Soil Level
(Change
Cycle Time)
Pause
Cancel
Delay Start - To start the washer at a later time,
press the DELAY button until the desired delay
start time (in hours) shows in the Display, then
select START. The countdown to the start time
will show in the display.
Soil Level- Pressing this button willchange the
length of the wash cycle. Heavy will add time to a
normal wash cycle, light will shorten a normal
wash cycle.
Pause/Cancel - Pressing this button will allow
changing any option or changing a wash cycle
aft er the wash cycle has begun. Press the
PAUSE/CANCEL
button, select the desired Op-
tion, press and hold the START button for one (1)
second. To cancel a cycle and select a new one,
press the PAUSE/CANCEL
button, select the new
cycle, select the desired options, press and hold
the START button for one (1) second.
Extra Gycle
Selection
Wash Cycle
Selector
Status Indicators - These lights show which
portion of the cycle the washer is operating. They
also indicate when additional items can be added
to the wash cycle and when the controls are
locked.
Extra Cycle Selection - The Rinse/Spin selec-
tion operates a rinse and spin cycle only. This
cycle combines fast speed tumbling and extra high
speed spin. The spin speed can be reduced by
selecting a speed from the SPIN SPEED modi-
fier.
Wash Cycle Selector - Choose a Wash Cycle
by selecting the button next to the desired cycle.
Each cycle is designed for different types of fab-
ric and soil levels. (See Table 2-1, Page 2-4)
Display - The display provides such information
as time remaining for selected wash cycle and
error codes.
Fig.2-7
2 - 3