Reassembling And Reinstalling The Tub Assembly - Kenmore 110.42822200 User Manual

The two piece tub is held together with a number
of metalclamps which can be removed by prying
them off with a flat bladed screwdriver. (Fig. 3-
s7)
The tub can now o" "?o^l^u!oand the drum can be
pulled from the back half of the tub. (Fig. 3-38)
Fig.3-38
R E A S S E M B L I N G A N D
R E I N S T A L L I N G T H E
T U B A S S E M B L Y
When reassembling and reinstalling the tub
assembly, take note of these special proce-
dures.
1. When reassembling the tub, be sure
to install all the metal clips all around
the tub. A hammer may be necessary
to do this.
2. When reinstalling
the heater element,
be sure it is inserted properly in the
retainer inside the tub. (Fig. 3-39)
Heater Glip
Fig.3-39
When reinstalling the tub, be sure to
hook the springs into the holes to-
wards the front of the tub.
A small piece of duct tape may be
necessary to hold the flat nut in place
when replacing the front bottom con-
crete weighl. (Fig. 3-40)
",rli''
J .
4 .
Fig.3-40
3 - 1 0