Information Codes - Kenmore 59229212 Owner's Manual And Installation Instructions

The Washer may display information codes to help you understand what is occurring with your Washer better .
CODE SYMBOL
26
Kenmore OEM washer_592-29212_DC68-03133J-02_EN.indd 26
Informati on codes
MEANING
The Water Level sensor is not
working properly.
Your Washer has tried to fill but was
unsuccessful.
Check if the hot water supply hose
is connected.
Your washer is not draining. It can
also mean that the unit senses a
small clog while draining.
Your Washer has tried to fill but has
not reached the proper water level.
Unbalanced load prevented your
Washer from spinning.
Lid is open when washer is running. Close the lid tightly and restart the cycle. If the
Your washer failed to lock the lid.
The lid will not unlock.
Jammed Key.
Motor not running properly.
Communication error between
SUB PBA and MAIN PBA
Mems sensor problem.
Temperature sensor problem.
The hot/cold water hose
connection is not correct.
A fault is detected in the water
level sensor.
SOLUTION
Call for service.
Make sure the water faucets are open all the way.
Check for kinked hoses.
Check the inlet screens on the fill hoses.
If you use a Flood Safety Device, then please
remove the device and connect the water hoses
directly to the unit.
You must connect the hot water supply hose
because hot water is supplied by the Auto
Temperature Control (A.T.C.) function.
Do the following:
Check for kink drain hose
1) Turn off the unit and turn it on again.
2) Select only the Spin Cycle.
3) Press the Start/Pause to drain the water.
If it still does not drain, call for service.
Call for service.
Make sure that water faucets are open all the way.
Redistribute the load, press the Start/Pause button.
Make sure that the washer is levell.
code reappears, call for service.
Close the lid tightly and restart the cycle. If the
code reappears, call for service.
Make sure the lid is firmly closed.
Push the Power button to turn off your washer,
then turn it on again. If the code reappears, call
for service.
Call for service
Restart the cycle pressing the Start/Pause
button. If the code reappears, call for service.
Call for service.
Call for service.
Restart the cycle.
If the code reappears, call for service.
Please connect the hot/cold water hose
connection correctly.
Call for service
2015/12/16 18:41:30