Installing The Pedestal - Kenmore 110.42822200 User Manual

1
t .
Installing the Pedestal
Open the pedestal drawer. Remove
the envelope taped inside the drawer.
This envelope contains four (4)
# 1 2 x 5 / 8 " ( 1.6 cm) he x h e a d sh e e t
metal screws that will be used in Steps
4 a n d 5 .
Remove the Phillips head screw from
both drawer sides and set the aside.
(Fig. 1-3) Remove the drawer and set it
aside. Push the slides back into the
pedestal.
Fig. 1-3
lf the washer has feet installed,
remove them. DO NOT install the feet
that came with a new washer.
Partially install the two (2) lower
#12 x 5/8" (1 .6 cm) hex head sheet
metal screws leaving a space of about
318" (2 cm) between the screw head
and the bottom of the washer.
(Fis. 1-4)
Move the pedestalagainst the washer
bottom. Slide the pedestal's keyhole slots
over the lower two (2) partially installed
screws. (Fig. 1-5)
Fig. 1-5
Lift the pedestal toward the front of the
washer and install the two (2) remaining hex
head sheet metal screws. Do not tiqhten
completely.
6. Tip the washer and pedestal
assembly back to an upright position.
Remove protective cardboard.
7. Slide the washer close to its final
location.
Helpful Tip: to make sliding the washer to
its final location easier, spray the floor behind
the washer with window cleaner.
lf the washer is still in its packaging, follow
the instructions on the packaging and re-
move it.
8. Follow the Installation lnstructions that
came with the washer to finish
installing or reinstalling. (i.e., hoses,
vents, etc.)
9. Level the washer from side to side
and front to back.
Place a level on the top. Locate the
114" (6.4 mm) hex nut on the top of
each pedestal foot. Reach inside the
pedestal and use a 114" (6.4 mm) hex
head ratchet or open-end wrench to
adjust the feet up or down as needed to
levelthe washer. (Fig. 1-6)
z .
4 .
rir|ltr !*lm
lN!r*firn|
Fig. 1-4
1 - 7