Table of Contents
Advertisement
11. USER C-CARD
The optional User C-CARD is used to back up Marks, Routes, and Tracks stored in your
GPS Chart Plotter's memory. In the USA the User C-CARD is available directly from
Jeppesen Marine at 800/424-2627. The User C-CARD is similar to a backup disk used with
a PC, in case you have to clear the RAM to resolve an issue or load new software, or if you
would like to transfer Waypoint, Track and Route information from one STANDARD
HORIZON GPS Chart Plotter to another.
11.0
USER C-CARD MENU
This optional card is similar to using a floppy disk or memory stick on a PC to backup your
files or to transfer the information that you have stored to a friends GPS Chart Plotter. The
information shown below will assist you to transfer the User Points, Routes and Track
history to the optional User C-CARD.
1
Time of file creation
2
Date of file creation
Type of data contained in the
3
file (Mark file, Waypoint file...)
4
File name
5
Number of Selected file
Information on stored User
6
Points on Internal Memory
11.0.0 Formatting the optional User C-CARD
1.
Press [MENU], move
2. Move the ShuttlePoint knob to highlight USER C-CARD and press [ENT]
3. Move the ShuttlePoint knob to highlight FORMAT and press [ENT].
4.
A popup Warning window will to confirm you want to format the User C-CARD.
5. Select
YES and press [ENT] to confirm (select NO otherwise). The format of User
C-CARD must be done before using a new User C-CARD: this operation prepares the
User C-CARD to receive and store information.
Formatting permanently erases all files previously saved on the User C-CARD.
11.0.1 Transferring files to the optional User C-CARD
1. Remove a
C-MAP B
User C-CARD into the slot.
2.
Press [MENU], move
CPF180i and CPF300i
4
5
6
Figure 11.0 - User C-CARD Menu
the ShuttlePoint knob to highlight USER POINTS and press [ENT]
NOTE
NT
+
J
/MAX
Y
EPPESEN
the ShuttlePoint knob to highlight USER POINTS and press [ENT]
C-CARD if present and insert the optional
1
2
3
.
.
.
Page 87
Advertisement
Table of Contents
