The Sensitivity Time Control (Stc) Soft Key; System Information Page; The System Update Menu - Standard Horizon FF520 Owner's Manual
50/200khz black box fish finder
Hide thumbs
Also See for FF520:
- Installation and operation manual (45 pages) ,
- Owner's manual (42 pages) ,
- Owner's manual addendum (1 page)
Table of Contents
Advertisement
3.1.3c The R
ANGE
By pressing [R
ANGE
LOCK and AUTO.
If MANUAL is selected move the ShuttlePoint knob up or down will adjust the depth vale in
10Ft steps. To adjust the Shift move the ShuttlePoint knob to the Left or Right.
When BOTTOM LOCK is selected, moving the Shuttlepoint knob up or down to adust the
Bottom range 10Ft at a time.
If AUTO RANGE, the range value is set automatically by the FF520 and it cannot be
changed by the user.
3.1.3d The F
REQUENCY
Pressing the [FREQUENCY] softkey toggles the FF520 output frequency between 50,
200kHz and Auto. The current value or Frequency is shown on a window right over the
[F
] label. The [F
REQUENCY
200kHz Dual page.
3.1.3e The Sensitivity Time Control (STC) Soft Key
The [STC] changes the STC value between OFF/SHORT/MID/LONG/CUSTOM. The
current value of STC is shown on a window right over the [STC] label. Move the ShuttlePoint
knob left or right will adjust the value.
3.2
SYSTEM INFORMATION PAGE
For troubleshooting you maybe asked by a Standard Horizon Product Support Technician
for the software version of fish finder. The following procedure is how to access this
information.
1. From the Chart Page press [MENU] key to open the Main Menu
2. Move the ShuttlePoint knob to highlight ABOUT... and press [ENTER] or move the
ShuttlePoint knob to the right.
3. A window will be shown with the system information on the Fish Finder Library version
and on the Fish Finder module type and version.
4. Press [CLEAR] to exit.
3.2.0
The System Update menu
The System Update menu allows downloading the Fish Finder firmware into the Fish Finder
device. To select this menu follow the procedure:
1. From the Chart Page press [MENU] key to open the Main Menu.
2. Move the ShuttlePoint knob to highlight ABOUT... and press [ENTER] or move the
ShuttlePoint knob to the right.
3. A window will be shown with the system information.
4. Press [MENU].
5. Move the ShuttlePoint knob to highlight UPDATE BBFF FIRMWARE SOFTWARE and
press [ENTER] or move the ShuttlePoint knob to the right.
6. The current Fish Finder firmware version is shown in the System Update window that
appears on the screen. Insert the C-CARD with the firmware in one of the chart plotter
available slots, and the press [ENTER] to update.
FF520
Soft Key
] the window switches to the next RANGE status: MANUAL, BOTTOM
Soft Key
] is not available when the Fish Finder show 50 and
REQUENCY
Page 23
Advertisement
Table of Contents
