Table of Contents
Advertisement
ADDITIONAL UPS FEATURES
Table 1. DIP Switch Settings
* Default position
Network Transient Protector
The network transient protector, shown in Figure 19, is located on the
rear panel and has jacks labeled IN and OUT. This feature
accommodates a single RJ-45 (10BaseT) network connector.
Low voltage models can also accommodate an RJ-11 telephone
connector that provides protection for modems, fax machines, or other
telecommunications equipment. As with most modem equipment, it is
not advisable to use this jack in digital PBX (Private Branch Exchange)
environments.
NOTE DO NOT connect any telephone or fax/modem equipment to the 230V models; only
network protection is available for 230V models.
1.
2.
40
t
Avaya
Line Interactive RM UPS Site Preparation, Installation and Operator's Manual
Output Voltage
Input Voltage Range
110V
99V–116V
120V*
108V–127V*
Output Voltage
Input Voltage Range
220V
198V–233V
230V*
207V–243V*
240V
216V–254V
Connect the network or telephone (low voltage models only) cable
to the jack labeled IN.
Connect the input connector of the equipment you are protecting to
the jack labeled OUT.
Figure 19. Network Transient Protector
120V Models
DIP Switch 1
ON
OFF
230V Models
DIP Switch 1
ON
OFF
ON
In
Out
S
164201663 Rev 1
DIP Switch 2
OFF or ON
OFF or ON
DIP Switch 2
OFF
OFF or ON
ON
Advertisement
Table of Contents
