Fuses
Warning !
For continued protection against fire hazard :
Replace with the same type of fuse.
Refer replacement to qualified service personnel.
Switching on the projector
Push the power (mains) switch located on the back panel of the
projector to switch the projector ON and OFF :
if the switch is pressed in
if the switch is Not pressed in : OFF
The projector can be started up in the 'operational mode' (image
displayed) or in the 'stand-by mode', depending on the position of the
'power-up' DIP switch on the controller unit (see p.5-2). This DIP
switch is set during installation by a qualified technician. If you want
to change this start up mode, call a qualified technician.
Power indication lamp :
OFF
: no power
Green : projector in operational mode
Red
: projector in stand-by mode
When switching on the projector, with the power switch or via the
stand-by key, the projector can start up in two ways if the "CRT run
in cycle" option is switched OFF :
a full white image (projector warm up) or
immediately image display.
The way of starting up can be set in the service mode.
5975857 BARCOGRAPHICS 1208s 220197
: ON
Cover plate (side view)
metal bottom plate
inside projector
cabinet
Top view marked area
AC power
Fuses
230 Vac
T6.3A/250V (2x)
120 Vac
T10A/250V (2x)
AC power connection
Order Number
R314145
R314154
T 1
PROJECTOR MODE
POWER/MAINS
EO)
GREEN : operational
RED : stand-by
PORT 2
(S-VIDEO)
ON
OFF
ON
75 ohm
hm
352
6-3