Installation Set-Up; Access To Controls; Opening The Top Cover; Removing The Top Cover - Barco R9000893 Installation Manual

4

INSTALLATION SET-UP

Access to Controls

Opening the top cover

During the projector set-up and the installation it is necessary to open
the top cover. Follow the procedure as described below :
* turn both lock screw with a screwdriver or a coin counter clockwise;
* lift up and pivot the top cover.
WARNING :
The projector's top cover is not supported with locking hinge. Open
with care and support the cover with your hand.

Removing the top cover

During some installations it will be convenient to remove the top cover
from the projector totally.
Proceed as follows :
loosen the screw locks by turning a quarter counter clockwise.
pull out the hing-joints.
left up the top cover.
5975857 BARCOGRAPHICS 1208s 220197
Lock screws
Installation set-up
4-1