Table of Contents
Advertisement
6
AC POWER CONNECTION
AC Power (mains) cord connection
Use the supplied cord to connect your projector to the
wall outlet. Plug the female power connector into the
male connector at the back of the projector.
This projector may be connected to an IT-power sys-
tem.
Preparing your power cord
Mains lead (power cord) with CEE7 plug
As the colours of the wires in the mains lead of this apparatus may not
correspond with the coloured markings identifying the terminals in
your plug, proceed as follows:
The yellow/green wire is ground and must be connected to the
terminal in the plug which is marked by the letter E or by the safety
earth symbol or coloured yellow and green.
The blue wire is neutral and must be connected to the terminal
marked with the letter N or coloured black.
The brown wire is the line and must be connected to the terminal
marked with the letter L or coloured red.
The wires of the delivered mains lead (power cord) are coloured in
accordance with the following code :
Yellow and Green : ground
Blue
: neutral
Brown
: live
Power cord with an ANSI 73.11 plug
The wires of the delivered mains lead (power cord) are coloured in
accordance with the following code :
Yellow and Green : ground (earth)
White
: neutral
Black
: live
5975857 BARCOGRAPHICS 1208s 220197
V NOM
120/230 Volt
I MAX
7/5Amp
FREQ
50/60Hz
RS232 IN
RS232 OUT
IR
AC power connection
REMOTE
685
6-1
Advertisement
Table of Contents
