Connecting The Ir Blaster; Checking The Ir Blaster; Figure 3-7 Ir Blaster Installed - Motorola DCT6200 Installation Manual

3-10 Installation

Connecting the IR Blaster

To connect the IR Blaster:
Fit the transmitter into the mounting bracket (refer to Figure 3-6).
1
Plug the mini-pin connector into the
2
illustrated in Figure 3-7:
Figure 3-7
IR Blaster installed
TO
TV/VCR
CABLE
IN
Remove the adhesive tape cover from the mounting bracket.
3
Position and press firmly to attach the mounting bracket to the IR receiver on the VCR. Be
4
careful to route the wire so that it does not prevent loading tapes.

Checking the IR Blaster

The IR Blaster is now located near the receiver and the VCR can be controlled through the
DCT*. As a final check, operate the VCR using the remote control from various positions in the
room. If the IR Blaster is obstructing the IR receiver on the VCR, move it slightly.
DCT6200\DCT6208 Installation Manual
jack on the rear panel of the DCT* rear panel as
IR
ETHERNE T SPDIF
R AUDIO IN L
IR DVI-D OUT
AUDIO OUT
TV
USB
Pass Card
Refer to text to locate
IR receiver on VCR
DCT6200/DCT6208
VIDEO
IN OUT
IEEE 1394
S-V IDEO
Pr
Pb
Y
OPTICAL
SPDIF
VCR