Garmin GNS 430 Pilot's Manual & Reference page 23

Once the direct-to or fl ight plan is confi rmed, the whole range of instrument pro-
cedures is available to you. Departures (SIDs), arrivals (STARs), non-precision and
precision approaches are stored within the NavData card and available using the
(procedures) key.
To display the procedures page, press
The steps required to select and activate an approach, departure or arrival are identi-
cal. In this introductory section, we'll show examples of the steps required to select an
approach, but keep in mind the same process also applies to departures and arrivals.
To select an approach, departure or arrival:
1. Rotate the small right knob (
Arrival?" or "Select Departure?") from the procedures page.
E
2. Press to display a list of available procedures for the arrival (when using approaches or
STARs) or departure (when using SIDs) airport.
3. Rotate the small right knob (
4. For approaches, a window appears to select the desired initial approach fix (IAF) or provide a
"vectors" option to select just the final course segment of the approach. Rotate the small right
a
knob ( ) to select the desired option and press
inbound course beyond the final approach fix, allowing you to intercept the final course seg-
ment beyond its normal limits.)
5. For departures and arrivals, a window appears to select the desired transition. Rotate the small
a
right knob ( ) to select the desired option and press
In your fl ight plan or direct-to, the departure or arrival airport is replaced with the
sequence of waypoints contained within the selected procedure.
P .
a
) to select the desired option ("Select Approach?", "Select
a
) to select the desired procedure and press
E . (The "vectors" option extends the final
E
.
P
E .
Press the
page. Rotate the large right knob (
select the desired option.
A window will appear to select the desired
procedure. Use the large right knob (
make your selection.
TAKEOFF TOUR
IFR Procedures
P
key to display the procedures
d
) to
d
) to
15