Garmin GNS 430 Pilot's Manual & Reference page 141

To select a VLOC frequency from the VOR or nearest VOR pages:
1. Select the desired page from the main pages. (See page references on the preceding page.)
2. Press the small right knob (
3a. Rotate the large right knob (
4. Press to place the frequency in the standby field of the VLOC window.
E
V
5. Press to activate the selected frequency.
6. Press the small right knob (
For duplex COM operations, the VLOC receiver may be auto-tuned from
the nearest flight service station page. See page 126 for more info.
When selecting a VOR or ILS approach, manual tuning of the VLOC receiver is not
required. Once the approach procedure is "Loaded" or "Activated", the GNS 430 will au-
tomatically place the proper frequency in the standby fi eld of the VLOC window. If you
wish to use this frequency, simply press
tion on approach procedures is provided in Section 5, beginning on page 66.
To select an approach and automatically tune the proper VLOC frequency:
1. Select the destination airport using the
plan.
2. Press the key to display the procedures page.
P
3b. Rotate the large right knob (
) momentarily to activate the flashing cursor
r
d
) to highlight the frequency for the desired VOR.
r ) to remove the flashing cursor.
V
to activate the frequency. Additional informa-
key or as the last waypoint in the active flight
D
d
) to highlight "Select Approach?" and press .
E
{continued}
VLOC RECEIVER
Auto-tuning
8
a
b
133