Table of Contents
Advertisement
1.5.1 TO CONNECT A TWISTED PAIR CABLE
Twisted pair (unshielded twisted pair cable for 10BaseT/100BaseT) uses an RJ-45 con-
nector that connects to the back of the iR-M2 (see F03-105-01 on page 3-6).
1. Shut down and power off the iR-M2 before connecting it to any network device (see
page 3-15).
2. Connect the network cable to the RJ-45 connector on the back of the iR-M2.
A Category 5 unshielded twisted pair (UTP) network cable must be used for 100BaseT.
3. Configure Setup options.
It is the network administrator's responsibility to configure Setup according to the net-
work and user environment. Refer the network administrator to the Configuration Guide
for Setup information.
4. After configuring Setup options, verify the network connection.
Once the network connection has been made and the iR-M2 has the correct Setup con-
figuration, the iR-M2 should be available on the network.
The network administrator should perform any additional network setup, verify the net-
work connection, verify that the iR-M2 appears in the list of printers, and print a few
test documents from a networked computer that will use the iR-M2. (For more informa-
tion, see the Configuration Guide.)
COPYRIGHT © 2002 CANON INC.
2000 2000 2000 2000
NM-PDL REV.0 JULY 2002
CHAPTER 3 CONNECTING THE iR-M2
3-7
Advertisement
Table of Contents
