Table of Contents
Advertisement
5. When the following screen is displayed, select "Yes".
If you select "NO", system CD-ROM gets out of the CD-ROM drive auto-
matically. Also when the installation of the system software is finished, sys-
tem CD-ROM gets out of the CD-ROM drive automatically.
Memo
Therefore, open a CD-ROM drive door when you install system software.
6. Following the startup diagnostics, the system software installation process begins imme-
diately. The Control Panel displays the following screens:
1. Disk Format
2. Base Install
3. Platform Install
4. Diablo Install
5. Kernel Install
7. At the message "Please remove CD," remove the system software CD, and then close the
CD-ROM drive drawer.
The system shuts down and reboots automatically. Wait as messages appear indicating
that the system is rebooting. Do not push any buttons during this time and ignore the
message Press any button to enter config mode that appears on the Control Panel while
the system reboots.
8. When the Select Language screen appears, scroll to the appropriate language, and then
select OK.
9. When the Select Market Region screen appears, scroll to the appropriate language, and
then select OK.
The system restarts and the Control Panel displays the messages System booting. Please
wait . . . and Restarting server.
10. When the Setup Menu displays, configure Setup using the Configuration page you
printed earlier.
Bypass any settings that are not included on the Configuration page if it is more appro-
priate for the network administrator to set them. For more information, see the Configu-
ration Guide.
11. Reinstall fonts, user software, or custom simulations that may have been deleted when
you installed system software.
COPYRIGHT © 2002 CANON INC.
6. Memory config update
7. LCD Install
8. System Install
9. System Install, Extracting
10. Installation is in progress
2000 2000 2000 2000
NM-PDL REV.0 JULY 2002
CHAPTER 4 SERVICE PROCEDURE
11. Installation was successful
Select
4-57
Advertisement
Table of Contents
