2 Checking the customer site
Before you install the iR-M2, check site conditions and inform the customer of any
installation requirements.
2.1 Copier Model
I What copier model is installed?
I Is the service mode COPIER>OPTION>INT-FACE>IMG–CONT set to 4?
I Has the INTERFACE BOARD been installed on the copier?
I Is there space near the copier for the iR-M2?
Make sure that there is space for the iR-M2. Allow enough space at the back panel for
the cables to route easily and at the side panel so that the iR-M2 does not interfere with
use of or service to the copier (such as clearing a paper jam). You may need to move the
copier out from the wall so that its interface connectors are accessible.
I Does the copier require service or adjustments?
Copy the copier test page before you install the iR-M2.
After getting approval, complete the copier service needed.
COPYRIGHT © 2002 CANON INC.
20cm / 8inch min.
2000 2000 2000 2000
CHAPTER 2 PREPARING FOR INSTALLATION
20cm / 8inch min.
F02-201-01
NM-PDL REV.0 JULY 2002
Back side
iR-M2
Front side
2-3