Table of Contents
Advertisement
4.7.3 TO REMOVE THE CD-ROM DRIVE FROM THE BRACKET
Spare CD-ROM drives are shipped as a complete assembly that includes the
CD-ROM drive, bracket, and connector adapter and are not spared sepa-
rately. The following procedures are provided as reference only.
1. Remove the two screws that attach the connector adapter to the CD-ROM drive, and
then remove the connector adapter from the CD-ROM drive (see F04-407-03).
Make sure to pull the connector adapter straight out from the CD-ROM drive. Do not
twist the connector adapter while removing it.
2. Remove the four screws that attach the CD-ROM drive to the bracket and slide the drive
out the front of the bracket.
Make sure not to damage the EMI gasketing around the edge of the bracket as you re-
move the drive.
Front of bracket
Screw
(1 of 2)
Connector
adapter
F04-407-03 Removing the CD-ROM drive from the bracket
COPYRIGHT © 2002 CANON INC.
2000 2000 2000 2000
NM-PDL REV.0 JULY 2002
CHAPTER 4 SERVICE PROCEDURE
CD-ROM drive
Screw
(1 of 4)
4-51
Advertisement
Table of Contents
