To Replace The User Interface Board In The Front Panel - Canon FY8-13HW-000 Service Manual

4.1.2 TO REPLACE THE USER INTERFACE BOARD IN THE FRONT
PANEL
1. Position the user interface board in the front panel at an angle so that the top edge of the
board fits under the top guides (see F04-401-03).
The board should be positioned so that the button pads on the front of the board line up
with the buttons installed in the front panel.
2. Push the board down into the front panel until the snap tabs hook over the edges of the
board.
3. Attach the UIB cable to connector J3 on the user interface board.
Make sure the connector levers close securely around the cable connector.
4. Replace the front panel (see F04-202-01 on page 4-7).
5. Reassemble the iR-M2 (see page 4-13) and verify its functionality (see the connection
verification steps described in F04-303-03 on page 4-15).
COPYRIGHT © 2002 CANON INC. 2000 2000 2000 2000 NM-PDL REV.0 JULY 2002
CHAPTER 4 SERVICE PROCEDURE
4-21