Table of Contents
Advertisement
1.3 Accessing Internal Components
If the iR-M2 is powered on, make sure to shut down the system before you access the in-
ternal components. Always use the following procedures when opening the iR-M2 for in-
spection or service.
Remember that when the iR-M2 is powered off, network access to the
copier is interrupted. Always get permission from the network administrator
before you take the iR-M2 off the network.
Memo
1.3.1 TO SHUT DOWN THE iR-M2
Always verify that the iR-M2 is not being used before you shut it down.
1. Make sure that the Info screen reads Idle.
When Printing or Ripping appears on the Control Panel, the iR-M2 is currently process-
ing a job. Idle appears in the Info screen when the iR-M2 is finished processing the job.
2. At the Idle screen, press the Menu button once to display the Functions menu.
3. Scroll to select Shut Down from the Functions menu.
4. At the next screen, select Shut Down System.
The message It is now safe to power off the system.... appears.
5. Power off the iR-M2 using the power switch on the back panel (press 0).
6. Disconnect all cables from the back panel.
COPYRIGHT © 2002 CANON INC.
2000 2000 2000 2000
NM-PDL REV.0 JULY 2002
CHAPTER 4 SERVICE PROCEDURE
Use the line selection button to
the right to select Shut down.
4-3
Advertisement
Table of Contents
