Table of Contents
Advertisement
CHAPTER 4 SERVICE PROCEDURE
a. TO REMOVE THE HDD
1. If you are removing the HDD in order to install a new drive, first give the network ad-
ministrator the opportunity to print the Job Log and to save any custom simulations.
Also, print the Configuration Page and the Font List from the Functions menu (if pos-
sible; see page 4-55 for a detailed description).
2. Shut down and open the iR-M2 (see page 4-3 and page 4-4).
3. Remove the front panel (see page 4-7).
4. Remove the 4-pin power supply cable from the HDD.
5. Remove the HDD ribbon cable from the HDD by pulling the connector (not the cable)
straight out from the HDD.
6. Remove three of the four screws that attach the HDD to the chassis (see F04-406-02).
7. While supporting the HDD, remove the fourth screw.
HDD
8. Remove the HDD from the chassis and place it in an antistatic bag.
Do not unscrew the screws on the HDD cover. Loosening these HDD
screws will break the seal and void the HDD warranty.
Do not touch the drive with magnetic objects (such as magnetic screwdriv-
ers), and avoid placing items such as credit cards and employee ID cards
that are sensitive to magnets near the HDD.
4-46
F04-406-02 Removing the HDD
COPYRIGHT © 2002 CANON INC.
Scews (1 of 4)
2000 2000 2000 2000
NM-PDL REV.0 JULY 2002
Advertisement
Table of Contents
