Table of Contents
Advertisement
1 Installation
After you unpack or service the iR-M2, power on the system and allow diagnostics to run
before you connect the iR-M2 to the copier and the network. Diagnostics run automatically
during startup to check the iR-M2 for internal problems.
1.1 Preliminary Checkout
The following procedure describes how to connect power and start the iR-M2.
1.1.1 TO CONNECT POWER AND START THE iR-M2
1. Connect the power cable to the power connector at the back of the iR-M2 (see F03-101-
01 below).
2. Make sure the power switch is in the off position (press 0), and then connect the other
end of the power cable to a wall outlet.
Power connector
Power switch
3. Power on the iR-M2 using the power switch on the back panel. The power supply auto-
matically senses the correct voltage.
4. Allow startup to proceed without interruption while you watch the iR-M2 Control Panel.
Do not press any buttons on the Control Panel.
5. Wait for the iR-M2 to reach the Idle screen to confirm that the iR-M2 is operating prop-
erly.
When the iR-M2 reaches the Idle screen, you are ready shut down and connect the net-
work and copier interface cables. Setup options should be configured after making these
connections. The network administrator is responsible for configuring Setup according
to the network and user environment. Refer the network administrator to the Configura-
tion Guide for Setup information.
The message Copier connection failure. Reboot may appear on the Control
Panel the startup process is complete. After you shut down the iR-M2, con-
nect the it to the copier, and then power back on, the message will no longer
Memo
appear.
6. Following a successful startup, shut down the iR-M2 (see page 3-15).
COPYRIGHT © 2002 CANON INC.
F03-101-01 iR-M2 power
2000 2000 2000 2000
NM-PDL REV.0 JULY 2002
CHAPTER 3 CONNECTING THE iR-M2
3-1
Advertisement
Table of Contents
