Power; Network; Parallel Port; System Contact Person - Canon FY8-13HW-000 Service Manual

CHAPTER 2 PREPARING FOR INSTALLATION

2.2 Power

I Is there a dedicated, grounded electrical outlet near the copier for the iR-M2?
Locate the grounded electrical outlet that will supply power to the iR-M2. You should
not run the iR-M2 and the copier on the same circuit. Make sure to use a surge suppres-
sor for the iR-M2 if the customer has provided one.
• Do not use a 3-prong adapter in a 2-hole ungrounded outlet.
• Do not use an extension cord.
• Do not plug the iR-M2 into a circuit with heating or refrigeration equipment
(including water coolers).
• Do not plug the iR-M2 into a switchable wall outlet. This can result in the iR-M2 be-
ing turned off accidentally.

2.3 Network

I What is the network cable and connection type?
• Unshielded twisted pair (10BaseT/100BaseT)
• Optional Token Ring (shielded twisted pair or unshielded twisted pair?)
I Is the network connection ready and tested for iR-M2 installation?
To verify that the network is functioning before you attach the iR-M2:
• Ask the network administrator to print a document on a shared printer over the net-
work.
• Ask the network administrator to verify the computer and network requirements as
specified in Getting Started.

2.4 Parallel Port

I Is there space for both the iR-M2 and the PC that will be connected to the iR-M2?

2.5 System Contact Person

I Will the person responsible for the computers and the network be available at the time
set for installation? Get a name as a contact.
2-4
COPYRIGHT © 2002 CANON INC. 2000 2000 2000 2000 NM-PDL REV.0 JULY 2002