Table of Contents
Advertisement
3.3 Restoring and verifying functionality after service
Conclude your inspection and service by reassembling and verifying the iR-M2.
a.Reassembling the system
Use the following procedure to reassemble the iR-M2 after inspection or service.
3.3.1 TO REASSEMBLE THE iR-M2
1. If you removed the front panel, replace it (see page 4-8).
2. Position the iR-M2 so that it is resting on its side on a flat, anti-static surface.
3. Reseat all boards, cables, connectors, and other parts loosened or removed during in-
spection or service.
4. Insert the hooks on the bottom edge of the access panel into the slots in the chassis, and
then lower the access panel onto the chassis (see F04-303-01).
Be careful not to damage any ribbon cables; fold the ribbon cables inside the chassis be-
fore replacing the access panel.
5.
Press on the back edge of the access panel and slide it until the mounting holes are
aligned with the holes on the chassis.
The two tabs near the bottom of the inside front panel snap into the chassis cover. Push
the chassis cover and the front panel together to achieve a snug fit. See F04-202-01 on
page 4-7 for tab locations.
6. Replace the four screws that attach the access panel to the chassis.
Back edge of
access panel
COPYRIGHT © 2002 CANON INC.
F04-303-01 Replacing the access panel
2000 2000 2000 2000
NM-PDL REV.0 JULY 2002
CHAPTER 4 SERVICE PROCEDURE
Screw and
screw hole (1 of 4)
Hook on
bottom edge
(1 of 3)
Slot (1 of 3)
4-13
Advertisement
Table of Contents
