CHAPTER 3 CONNECTING THE iR-M2
1.2 Connecting to the Copier
After completing the preliminary checkout, connect the iR-M2 to the copier. The iR-M2
communicates with the copier through a cable from the copier interface board to the inter-
face port on the copier.
1.2.1 TO CONNECT TO THE COPIER
1. Power off the copier.
Check with the network administrator or supervisor before powering off the copier.
2. Connect one end of the copier interface cable to the interface connector on the copier
and the other end of the cable to the iR-M2 copier interface connector (see F03-102-01
below).
Slot1
Slot2
Slot3
Slot4
Slot5
Slot6
3-2
F03-102-01 Copier interface connection
COPYRIGHT © 2002 CANON INC.
Copier interface port (RJ-45)
Copier interface cable
2000 2000 2000 2000
NM-PDL REV.0 JULY 2002