Powering Down; Unit Recovery; Rapid Eye Unit Installation Environment; Figure 2-5 Powering Up The Dvr - Honeywell Rapid Eye Installation Manual

Multi-media digital video recorder

Hide thumbs Also See for Rapid Eye:

Table of Contents

Installation

Powering Down

Figure 2-5

Powering Up the DVR

POWER

READY

ALARM

HDD

UP TO 5 SEC

Press and hold the power switch on the front of the DVR for up to five seconds.

Unplug the Multi-Media DVR from the uninterruptible power supply (UPS) or wall

outlet.

Power down the camera(s) and other hardware.

Power down the UPS, if in use.

Unit recovery is an internal diagnostic that seldom occurs and cannot be interrupted, even

by powering down the DVR. A unit recovery can take many hours, even dozens of hours on

DVRs with a large storage capacity. If unit recovery occurs repeatedly, contact Honeywell

Technical Support (see the back cover of this manual for contact information).

Installation of the equipment in a partially or completely enclosed space (such as a

multi-unit rack or lock box) should be such that the amount of air flow required for safe

operation of the equipment is not compromised.

This panel is available by

unlocking the front panel. The

READY, ALARM, and HDD LEDs

Rapid Eye V9-DSP

show through the front panel.

SW V9.0.12

Lock

READY

ALARM

HDD

Table of Contents