Configuring Ptz; Table 5-2 Ptz Drivers For Controllers And Domes - Honeywell Rapid Eye Installation Manual

Site Hardware

Configuring PTZ

a
56
Consistent Port Attributes
Honeywell recommends that if domes are to share a serial communications line, installers
should select domes that:
• Function at the same settings for: Baud Rate, Data Bits, Parity, and Stop Bits.
• Use the same PTZ drivers.
Caution Domes that require different PTZ drivers may not function as expected if
they are installed on the same port/serial communications line.
Use the View application to run a maintenance session. Use the Video tab to configure PTZ
settings. Multi-Media DVRs support the PTZ domes listed in
can support many types of PTZ software drivers at the same time. Refer to the
Multi-Media Digital Video Recorder System Administrator
PTZ dome.
Table 5-2 PTZ Drivers for Controllers and Domes
a
Driver (name) Baud rate
Bossware 19200
Honeywell fixed camera 9600
Intellibus 38400
Javelin 308 9600
Kalatel 9600 or 2400
Pelco D 4800, 9600, or 2400 Pelco D
Pelco P 2400
Rapid Dome/Orbiter 9600
SensorMatic RS422 4800
Ultrak (using VCL) 2400
Ultrak KD6 9600
The drivers are not listed alphabetically in the View application. A driver can be used with
domes other than those listed. For other domes, controllers, or PIT devices, refer to the
documentation provided with the device.
Caution After the installation, installers should communicate to the Multi SA: each
address used by the PTZ domes and the number of the port used for PTZ
on the Rapid Eye DVR.
Table 5-2. A Multi-Media site
Guide, for procedures to enable a
Support for (dome/controller/PIT device)
PIT device, to which domes are connected
Honeywell HCU484
ACUIX camera
Javelin 308 Controller
Kalatel KTD312 Cyberdome
Pelco P
RapidDome or Orbiter
SensorMatic RS422: Delta and Speed
Ultrak (configured as VCL)
KD6, HD6, HD6i
Rapid Eye™