Alarm Sensors; Connecting An Alarm Sensor; Inputs For Sensors; Configuration Using View Software - Honeywell Rapid Eye Installation Manual

Multi-media digital video recorder

Hide thumbs Also See for Rapid Eye:

Table of Contents

Alarm Sensors

Document 800-02607V3 Rev A

11/09

To connect alarm-type hardware to a Multi-Media DVR, use hookup wire in the 20-gauge

range.

Tools you may need:

•

A slot screwdriver (supplied). The screws are smaller than those for a 1/8 inch

screwdriver.

•

A wire stripper.

From the alarm wire tips, strip approximately 0.6 cm (1/4 inch) of insulation.

Insert each alarm wire into the screw-type, terminal connector on the ALARM terminal

strip: one wire to the numbered terminal connection and the other wire to ground.

Caution

To avoid short-circuits, ensure that bare wire is not visible at the rear panel.

Using View, start a Maintenance session for the Rapid Eye site. Wait until the System

Operational message appears. Click the Events tab. More tabs are displayed.

Click the Inputs tab.

Enter the name of an input in its Input box. You have the option of identifying inputs

that are not in use, such as input 7 and input 8 (see

You have the option of monitoring the activation of inputs and their deactivation by

selecting Log and Alarm, as needed.

By default, alarm/control inputs are configured as NO. Click NC or EOL, as needed.

Rapid Eye™ Multi-Media DVR Installation Guide

Figure

5-4).

Table of Contents